Sort by:
Stainless Steel Crank Handle
- Cast Stainless Steel crank handle with an updated Frigid design.
- Better handle with improved ergonomics and higher height and strength.
- Crank will no longer bend and potentially scratch the top of the head cap.
Bronze Crank Handle
- Cast Bronze crank handle. Classic design.
Wooden Crank Handle
- Wood crank handle with a brass shaft. Classic design.
*All Crank Handles fit Frigid Casket Lowering Devices*
The governor is a very important part for proper operation of the casket lowering device. If your device is making a clicking noise or experiencing intermittent lowering speeds, it may be time to replace your governor. Highly recommended to replace the governor brake assembly (4-GOV225) at the same time.
Bearing used for the top (fit into spider plate) and the bottom (fit into base of housing) of the worm/helical gear shaft. This part is very important to the proper operation of the speed control of the casket lowering device. If either bearing is seized or broken, the device could lower inconsistently or not at all. Great to keep in stock if you have multiple lowering devices in your shop. Bearings fit both Imperial and Master model lowering devices.
Part is sold in pairs. These steel balls sit on the bottom and top of the governor shaft. Very important to the proper operation of the governor as it will not spin smooth or evenly without them.
Assembly includes: Governor brake disc and leather, 2 governor brake studs, washers and nuts. If your lowering device clicks loudly or lowers intermittently, it may be time to replace the governor brake assembly.
A useful tool for adjusting the lowering speed of a Frigid Imperial or Master casket lowering device as well as tightening the Frigid Trocar Buttons.
This screw connects the side rail to the corner housing of the casket lowering device. Fits into the end of the side rail and slides through the hole on the 3/4" short link that sticks outside of each corner housing when the side rails are removed. Great to keep in stock at your garage.
Tubing Lock for Head and Tail end of Frigid Casket Lowering Devices. Works with both Imperial and Master Models.
Sits inside the cast housing of the Imperial and Master A head. This part helps keep the bottom of governor shaft spinning smoothly.
This screw is mounted on the spider plate and holds the Governor in place. The steel ball 4-GOV20 or 20L sits inside the top of the governor and on the bottom of this part. Important to replace from time to time to keep the governor spinning smoothly.
This is the bigger screw located on all variations of 29" tubing.
Sits inside the cast housing A head of Imperial and Master lowering devices.
Through 5 generations we have maintained the highest standards in manufacturing while also distributing some of the finest funeral and cemetery supplies throughout the world.
Through 5 generations we have maintained the highest standards in manufacturing while also distributing some of the finest funeral and cemetery supplies throughout the world.