Sort by:
This is the smaller Tubing Collar screw located on all 48" tubing as well as all variations of 29" tubes.
Purchase 2 of these if you are looking to replace them both on the governor. Works for Imperial and Master model lowering devices. Removal and replacement of pin required to replace this part.
Governor Brake Stud Nuts. Includes (2) nuts for the governor brake studs.
Spiral gear and brake handle used to stop the lowering on the lowering device. The spiral grooves can wear out over time and effect the braking power of the brake. Good to keep in stock if you have multiple lowering devices.
Bearing used to mount the shortlinks inside the corner housing of the casket lowering device. Shortlinks are the 3/4" square piece that sticks outside of the corner housing when the side rails are off of the device. One the inside of the housing, the shortlink mounts the bevel gear on the operating end and has a collar screw on the inside of the tail end of the device. These bearings are important to keep the side rails rotating smoothly and therefore lowering the casket consistently and smoothly. Be sure to specify whether for Imperial or Master model lowering device. 2 bearings per corner housing. Product sold ea.
Bearing used for the transmission shaft of the casket lowering device. 4 per operating end. Be sure to specify whether for Imperial or Master model.
These bearings fit inside the bearing housing and the housing of the inside of the operating end of the casket lowering device. There are 4 per operating end. Be sure to specify whether for an Imperial or Master model lowering device.
